Oil additive MAX MGSB and robotics geaxbox

The 1st stage: Add Lubricant Composition ATOMIUM MAX 200 to the engine oil through the oil filling neck at the rate of 7 – 10 ml of the lubricant per 1 L of engine oil, then drive the car till the next regular oil replacement (but no less than 2000 km). In case of a significant oil contamination (identify by the color of the oil on the dipstick or oil spots on filter paper) start the second stage of the treatment immediately.

Recommendations (after the 1st Stage):

• Change oil (in case of a significant engine contamination flushing is recommended);
• Replace oil and air filter, and begin the 2nd stage.

The 2nd stage: Add ATOMIUM MAX 200 to the new engine oil at the rate of 7 – 10 ml of the lubricant per 1 L of engine oil, and then drive in a regular mode till the next oil replacement.

The 3rd and the 4th stages of the treatment are similar to the stage 2.

Important notes:

• Before applying ATOMIUM MAX 200 shake the can thoroughly until natural sediments (active components) are totally dissolved.
• Apply ATOMIUM MAX 200 through the regular oil filling neck of the warmed-up engine.
• After applying ATOMIUM MAX 200 drive the vehicle for no less than 20 minutes in any mode (regular operation).
• It is not recommended to apply the Lubricant at existence of mechanical breakages of parts and assemblies.
• ATOMIUM MAX 200 is compatible to any type of engine oils and doesn't change their properties.
• To provide continuous level of engine protection it is recommended to apply ATOMIUM MAX 200 after 300 000 - 400 000 km of run, process at the rate of 5 ml of the lubricant per 1 L of engine oil (1 stage of treatment).
• To achieve the full level of protection apply Atomium  treatment of all vehicle parts is recommended, such as transmission gears, high pressure fuel pumps (diesel), hydraulic power steering etc.
• Admissible concentration increasing for the treatment with ATOMIUM is no more than 50 % (i.e. 20 ml of product per 1 L of oil).

First aid:

• In case of a contact with skin remove the material wash out with warm water, and then wash again with soap.
• In case of contact with eyes wash out eyes with large amount of water.
• In case of swallowing consult a doctor.

Precautionary measures:

• Does not pose a health hazard under normal conditions of use.
• In case of skin contact, wash affected area with warm water and then with soap and water.
• In case of contact with eyes, rinse them with plenty of water.
• If ingested, seek medical advice.

The tribological composition is designed to protect against wear, extend the life and restore the characteristics of diesel engines with a displacement of more than 5 liters (5000 cm3) during normal operation.

Notes:

• Shelf life 5 years. The date of manufacture is indicated on the bottle.
• It is not recommended to use in case of mechanical breakdowns of parts and assemblies.
• The composition of "MAX DVS" is compatible with any type of motor oils.
• The sediment at the bottom of the vial is the main working element of the composition "MAX DVS" - microparticles of minerals. It is extremely important to thoroughly mix the contents of the bottle before pouring into the engine oil system. (The color of the sediment, depending on the release batch, can vary from light green to dark gray and black).
• An overdose when adding the composition by 1.5 times is not dangerous for the engine and does not disrupt its operation.
• The composition of "MAX DVS" does not affect the characteristics and condition of parts made of composite materials, ceramics and rubber products.
• To ensure a constant level of engine protection, it is recommended to add the MAX ICE composition to the working oil every 300-400 thousand kilometers.